Sphere Bead Roller - LCBR001

APPROXIMATE DIMENSIONS:
70mm x 45mm x 15mm

Produces beads of 6mm, 8mm and 10mm

TO USE:
This Clay Bead Roller is an easy-to-use tool to create uniformly sized beads.
Place a small amount of clay into the bead roller and start sliding the two halves of the tool over each other and out pops a bead. If your bead ends up with a line down it, you probably have a little too much clay in the mould. Reduce the amount of clay and try again.

Since the Bead Rollers are 3D printed, they do have little lines, so depending on the type of clay you use, small lines may appear on the surface of the beads.

BEAD ROLLER CARE:
Please be gentle when using your bead roller. They are made from PLA filament which is durable but can be damaged if mistreated.
Hand wash with warm water & soap as desired. These are NOT dishwasher safe.
You may use gentle wet wipes to clean between uses.

Please Note: The colours may differ from those in the photos

If you have any questions about sizing or how to use your bead roller please contact me!